3D printer parts heatingcontroller, MKS MOS25 V1.0, for heat bed extruder MOS, module support big current, 25A
₹591
The superior performance of MOSFET (Max 280A).
An extra-large heat sink, the maximum current can be up to 30A or more.
Can use hot-bed output signal of Ramp1.4 and MKS series to control.
Can use the digital signal of 5-24v to control.
Out of stock
Description
Many control boards are not rated sufficiently to take the large DC currents generated by 3d Printer hotbeds and some of the higher-power hot heaters. This is particularly true for 12V systems.
You can largely eliminate problems of this nature by fitting a MOS25 FET heating controller to your heat bed circuit and ideally your hot-end circuit too. The MOS25 is rated for High current up to 25A, on no account should this be exceeded. 25A is 300 Watts at 12V. You must also ensure that when wiring to the board your wire is suitably rated for the expected current and terminated.
Features:
MKS MOS25 supports a high-power heated bed and supports a maximum current of 25A.
Package included:
1 x 3D printer heating controller MKS MOS25 V1.0 for heat bed extruder MOS
Additional information
| Weight | 0.038 kg |
|---|---|
| Dimensions | 11 × 9 × 3 cm |
| Item Type: | Module |
| Size (mm): | 60×50 |
| Compatibility | Heatbed Circuits, Hotend Circuits |
| Material: | Metal, Plastic |
| Rated Voltage (V): | 5 to 24 |
| Max. Current Capacity | 25A |
| Shipping Weight | 0.038 kg |
| Shipping Dimensions | 11 × 9 × 3 cm |
