Servo Driver Module Shield 16 Channel

517

The I2C input, PWM output control 16 roads, steering gear can 16 roads.
The steering gear power independent V + input maximum 6 V.
Logic signals and logical power independent output for 3V to 5 V.
40-1000 Hz frequency.
Terminal block for power input.
Reverse polarity protection on the terminal block input
Green power-good LED

Out of stock

SKU: A08891 Category:

Description

You want to make a cool robot, maybe a hexapod walker, or maybe just a piece of art with a lot of moving parts. Or maybe you want to drive a lot of LEDs with precise PWM output. Then you realize that your microcontroller has a limited number of PWM outputs! Here is the?Servo Driver Module Shield 16 Channel to help you out!!!
What now??You could give up OR you could just get our handy PWM and Servo driver shield. It??s now Arduino-ready and works with any Arduino that uses shields:?Uno,?Mega,?ADK, it??s all good.
Using only two pins, control 16 free-running PWM outputs! You can even chain up 62 breakouts to control up to 992 PWM outputs

It??s an I2C-controlled PWM driver with a built-in clock. That means that, unlike the TLC5940 family, you do not need to continuously send it the signal to tie up your microcontroller, it??s completely free running!
It is 5V compliant, which means you can control it from a 3.3V microcontroller and still safely drive up to 6V outputs (this is good for when you want to control white or blue LEDs with 3.4+ forward voltages)
6 address select pins so you can wire up to 62 of these on a single i2c bus, a total of 992 outputs ?? that??s a lot of servos or LEDs
Adjustable frequency PWM up to about 1.6 KHz
12-bit resolution for each output ?? for servos, that means about 4us resolution at a 60Hz update rate
Configurable push-pull or an open-drain output
The output enable pin to quickly disable all the outputs

We wrapped up this lovely chip into a breakout board with a couple of nice extras

Terminal block for power input (or you can use the 0.1?? breakouts on the side)
Reverse polarity protection on the terminal block input
Green power-good LED
3 pin connectors in groups of 4 so you can plug in 16 servos at once (Servo plugs are slightly wider than 0.1?? so you can only stack 4 next to each other on 0.1?? header
??Chain-able?? design
A spot to place a big capacitor on the V+ line (in case you need it)
330-ohm series resistors on all the output lines to protect them, and to make driving LEDs trivial
Solder jumpers for the 6 address select pins

We have a wide range of Servo Motors and compatible Servo Cables available?in our online store, click below to explore now
Servo Motors
Servo Extension Cable

Features :

The I2C input, PWM output control 16 roads, steering gear can 16 roads.
The steering gear power independent V + input maximum 6 V.
Logic signals and logical power independent output for 3V to 5 V.
40-1000 Hz frequency.

Package Includes :
1 x?Servo Driver Module Shield 16 Channel.

Additional information

Weight 0.105 kg
Dimensions 8 × 6.5 × 3 cm

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.