Size: 50 x 50 x 4.5 mm. Mounted hole size: 4 x M3. Power input (V): DC 7 ?? 26. Suitable for APM 2.5, 2.6, 2.8 pixhawk. Suitable for Quadcopter Hexacopter Octocopter. BEC Output: 3A 5V.
High-Speed STM32 processor Triple Redundant IMU Light Weight Isolated & Dampened IMU Compatible with Ardupilot and PX4. It can be configured with AeroGCS, Mission Planner, QGround Control software, etc. Limited Time Launch Offer !!!
Very small size & Lightweight MAVLink protocol framing and status reporting Interchangeable air and ground modules Micro-USB port UART interface Error correction corrects up to 25% of bit errors Configurable through Mission Planner and APM Planner The demonstrated range of several kilometers with a small Omni antenna
This is combo kit of Flight controller & ESC High performance & efficient flight controller & ESC Light weight, Easy to connect Compact in size Flight controller comes with ARM processor ESC is build to give best performance
SENSOR: ?CMOS 3.6mm lens Power supply: 12V DC Signal system: PAL/NTSC Min. Illumination 0.3 Lux / F1.2 S/N Ratio More than 48dB White Balance Auto AGC Auto Color/Black and White Auto
Ready to Connect to PIXHAWK FC with 6-pin connector Attached Receiver type 72-channel M8 engine Galileo-ready E1B/C (NEO-M8N) Nav. update rate1 Single GNSS: up to 18 HZ Acquisition Cold starts: 26 s Onboard Compass
Special for FPV image transmission Provide two version to choose: 5V Suitable for: RC Air Plane Output current: Constant 3A Output voltage: 2-6S( 5V version )
Built from quality glass fiber and polyamide nylon. Integrated PCB connections for direct soldering of your ESCs Pre-threaded brass sleeves for all of the frame bolts. Colored arms for orientation to keep you flying in the right direction. Large mounting tabs on main frame bottom plate for easy camera mounting. Easy assembly.
Input Voltage (V): MC: 4.8V~5.5V (recommended 2S~6S Lipoly). Supported ESC Output 400 Hz refresh frequency Supported Transmitters PCM or 2.4 GHz radio with at least 4 channels Power Consumption MAX: 1.5 W (0.3 A at 5 V) Operating Temperature: -10 to 50°C
No. of Channels:6 Model type:Glider/Heli/Airlane RF range(Hz):2.4000-2.485 Bandwidth (kHz):500 Band:160 RF Power: Less Than 20 dBm Sensitivity (dBm):1024 Low Voltage Alarm: Yes (less than 9V) DSC port:Yes(PS2; output: PPM)
ATmega328P with Arduino bootloader MAX7456 monochrome on-screen display FTDI cable compatible pinout Standard 6 pin ISP header 2 independent power sections with an LED indicator on each Solder jumpers for combining the power sections Compatible flight controller: APM2.5/2.6/2.8 Pixhawk PX4
8 Channel PWM input 8 motor outputs 12-way Auxiliary input and output Supports GPS, compass, telemetry and power module Onboard connections JST-SH with 1.0mm pitch Compatible with official Firmware and Groundstation.
"🎉 Enjoy exclusive discounts! Use coupon codes at checkout & get FREE delivery on eligible orders. Shop now! 🚚✨" Dismiss
