Axis: 2000 degrees/second 3-axis MEMS gyro. Input voltage: Max 16V on input rail and up to 35V 6s on the voltage sense line. Built-in FrSky telemetry inverter (shared w/main port). A modern 32-bit processor running at 3.3V/72MHz (STM32F103CB). Onboard MicroUSB for setup and configuration. Multi WiFi-based configuration software for easy setup.
Battery voltage monitoring. Built-in FrSky telemetry converter. Modern 32-bit processor (STM32 F103) running at 3.3V/72MHz. Onboard USB for setup and configuration. Modern GUI for all operating systems, Baseflight Configurator.
This is a breakout cable for the Naze32 flight controller This cable specially designed for open source flight controller such as Naze32 to connect with a radio receiver
5Hz position update rate. The cold start time of 38 s and?Hot start time of 1 s. Configurable from 4800 Baud to 115200 Baud rates. (default 9600). SuperSense ? Indoor GPS: -162 dBm tracking sensitivity. Support SBAS (WAAS, EGNOS, MSAS, GAGAN). Separated 18 x 18mm GPS antenna.
Ready to Connect to PIXHAWK FC with 6-pin connector Attached Receiver type 72-channel M8 engine Galileo-ready E1B/C (NEO-M8N) Nav. update rate1 Single GNSS: up to 18 HZ Acquisition Cold starts: 26 s Onboard Compass
Direct plug design, Works with most USB port and USB extension cable ?Low power consumption design Onboard 2×3 Pin AVR ISP port ?3pin servo connector can be used as servo or C2 connection Supports SIMONK and BLHELI ESC,?KKflashtool compatible KKflashtool and RapidFlash?compatible
Direct plug design, Works with most USB port and USB extension cable ?Low power consumption design Onboard 2×3 Pin AVR ISP port ?3pin servo connector can be used as servo or C2 connection Supports SIMONK and BLHELI ESC,?KKflashtool compatible KKflashtool and RapidFlash?compatible
Cable Length: 15cm. NZ GPS Suitable for Flight Controller NAZE 32, Interface 1 Pin??2.54. This GPS is customized for the Naze32 flight controller. Internal Ublox 7 series chip core of manufacture OEM.
