Brand: Orange Material: Glass Fiber Nylon Color: Grey No. of Blades: 2 The Orange HD Propellers 1245(12X4.5) Glass Fiber Nylon Gray comes with Epoxy resin cover. Very strong and lightweight.
Optical flow processing at 4×4 binned image at 120 (indoor) to 250 Hz (outdoor). Superior light sensitivity with 24×24 μm super-pixels. Onboard sonar input and mount for Maxbotix sonar sensors. PX4 Flow comes with the sonar already mounted and installed. USB bootloader. Onboard 16bit gyroscope up to 2000?/s and 780 Hz update rate.
Dimensions: 37 x 37 x 10 mm(L x H x W) Weight: 12 gm. SPI Gyro MPU6000 MicroSD Blackbox F4 Processor (F405) 5v3a SBEC Built-in Current Sensor On-Board OSD (controlled by Beta flight, FC over SPI bus) On-Board Video Filter (only can supply 5V to VTX and Camera) On-Board Voltage Regulator and Power supply (BEC)
Cable Length: 15cm. NZ GPS Suitable for Flight Controller NAZE 32, Interface 1 Pin??2.54. This GPS is customized for the Naze32 flight controller. Internal Ublox 7 series chip core of manufacture OEM.
Modulation type: GFSK DSC port: PPM/I-BUS/S.BUS Antenna length: 26mm(not including brass contacts) Power input: 4.0-8.4V No ground interference( transmitting and receiving 1m from the ground):?＞300m Operating current:40mA Channel delay: ＜15ms
Pack contains quality products All products are tested and ready to perform All essential equipment required to build a Racing Drone is included in this advanced combo pack.
ATmega328P with Arduino bootloader. MAX7456 monochrome on-screen display. +5V 500mA regulator for up to +12V supply input. FTDI cable compatible pinout. The standard 6-pin ISP header. Standalone, or with APM/ Flip / Flip32+ flight controllers.
Model: Mamba F4 pro V2 Input voltage: 2 ?? 6s LiPo support Gyroscope: MPU6000 (reserved external gyroscope interface) Firmware: BetaFlihgt 3.2.0 OMNIBUSF4SD Support Receiver: PPM, SBUS, IBUS, DSM2/DSMX Receiver (UART1) Integrated with OSD, support BF Ground Station adjust OSD Adjust the PID by OSD by remote control
MCU: STM32F405RGT6?32-bit processor IMU: ICM20689 (SPI) USB VCP Driver (all UARTs usable simultaneously; USB does not take up a UART) 3 hardware UARTS (UART1,3,6) 128 Mbit Dataflash chip for Blackbox logging 5v Power Out: 1.5 A max 3.3v Power Out: 200 mA max
