Trigger Voltage: 5 VDC Trigger Current : 20 mA Maximum Switching Voltage: 250VAC@10A; 30VDC @10A Single Pole Double Throw (SPDT) Configuration Power supply indicator lamp
No. of Channel: 4 Trigger Voltage: 5VDC Triode drive, increasing relay coil High impedance controller pin Pull-down circuit for the avoidance of malfunction Power supply indicator and Control indicator lamp Power supply and relay instructions, lit, the disconnect is off; The input signal, signal, common Terminal and start conducting;
5V 4-Channel Relay interface board and each one needs 15-20mA Driver Current. Equipped with high-current relay, AC250V 10A; DC30V 10A. Standard interface that can be controlled directly by microcontroller (for Arduino, 8051, AVR, PIC, DSP, ARM, ARM, MSP430, TTL logic). Indication LED’s for Relay output status.
Input voltage: 7 -26V Output voltage: 5V Output current: 3A (Max), the current should be controlled within 1.6A for working long hours Conversion efficiency: 96% (Max) Output ripple: < 30mV
Input Voltage : 2 Volt -5.5 Volts DC. The response time max ~ 60mS in fast mode, ~220mS at low power mode @VDD=3V. Sensitivity can adjust by the capacitance(0~50pF). Stable touching detection of the human body for replacing traditional direct switch key. Provides direct mode toggle mode by pad option(TOG pin). After power-on have about 0.5sec stable-time, during the time…
Power supply voltage(VCC): 2.0, 3, 5.5 V. Output high VOH: 0.8VCC V Output low VOL: 0.3VCC V Response time (touch mode) : 60 mS Response time (low power mode) : 220 mS Can replace the traditional touch of a button Four M2 screws positioning holes for easy installation
5m total length. 60 LEDs/m. 24-bit color control (8-bit PWM per channel). 16.8 million colors per pixel. The one-wire digital control interface. Each RGB LED draws approximately 50 mA at 5 V with red, green, and blue at full brightness. Waterproof.
"🎉 Enjoy exclusive discounts! Use coupon codes at checkout & get FREE delivery on eligible orders. Shop now! 🚚✨" Dismiss
