Channel: 1 channel Relay Voltage: 5V High impedance controller pin Pull-down circuit for the avoidance of malfunction One normally closed contact and one normally open contact Triode drive, increasing relay coil
With ESP8266 Wifi module,4-layers board design. Input overvoltage protection, input with TVS, when the voltage exceeds 33V, automatic protection will operate. Input overcurrent protection. 220V 10A relay, one normally open, one normally closed. One way optocoupler isolation input, TVS input protection.
Channel: 1 channel Relay Voltage: 24V High impedance controller pin Pull-down circuit for the avoidance of malfunction One normally closed contact and one normally open contact Triode drive, increasing relay coil
The 8550 transistor drive, driveability. A fixed bolt holes for easy installation. It has a relay status indicator led?Power LED(Green), 8 relay status indicator LED(Red) Relay control interface by single-chip IO. Low-level suction close, high-level release. Easy to use, simple 3 line structure.
Supply Voltage: DC 5V Quiescent Current: 5mA Maximum Operating Current: 190mA Trigger Mode: High and low-level trigger Load Voltage: DC 30V / AC250 Load Current: 30A Relay Life: more than 100,000 times
Trigger Voltage: 5 VDC Trigger Current : 20 mA Maximum Switching Voltage: 250VAC@10A; 30VDC @10A Single Pole Double Throw (SPDT) Configuration Power supply indicator lamp
No. of Channel: 4 Trigger Voltage: 5VDC Triode drive, increasing relay coil High impedance controller pin Pull-down circuit for the avoidance of malfunction Power supply indicator and Control indicator lamp Power supply and relay instructions, lit, the disconnect is off; The input signal, signal, common Terminal and start conducting;
