“FR120N Mosfet control Module Replacement” has been added to your cart. View cart
-
-
Add to cart
- Relay Boards
4 Channel 5V Relay Module with Optocoupler
- ₹169
- 5V 4-Channel Relay interface board and each one needs 15-20mA Driver Current. Equipped with high-current relay, AC250V 10A; DC30V 10A. Standard interface that can be controlled directly by microcontroller (for Arduino, 8051, AVR, PIC, DSP, ARM, ARM, MSP430, TTL logic). Indication LED’s for Relay output status.
-
-
-
-
Add to cart
- Relay Boards
ESP8266 ESP-01 5V WiFi Relay Module
- ₹216
- Onboard Module: ESP8266 wifi module; in AP mode it can connect with 5 Clients at the same time Operating Way: cellphone carried on wifi module; cellphone and wifi module carried on the same router, and use the APP to control relay Transmission Distance : 400m (max) Relay : 5V,10A/250V AC 10A/30V DC Baud Rate: 9600. Diode effusion protection; Short response time
-
-
-
-
-
Add to cart
- Relay Boards
5V Dual Channel Relay Module with Optocoupler
- ₹100
- Low Level Trigger Relay Module Two separate LEDs for On/Off indication of the Relay. Triggering input voltage 3.3V – 5V Two separate LEDs for On/Off indication of the Relay Triggering input voltage 3.3V – 5V 4) Back EMF protection Back EMF protection 2 LEDs to indicate when relays are ON. Works with logic level signals from 3.3V or 5V devices…
-
-
-
-
-
-
Add to cart
- Relay Boards
12V 4 Channel Relay Module
- ₹253
- 4-Channel Relay interface board and each one needs 15-20mA Driver Current. Both controlled by 12V and 5V input Voltage. Equipped with high-current relay, AC250V 10A ; DC30V 10A. Standard interface that can be controlled directly by microcontroller (Arduino, 8051, AVR, PIC, DSP, ARM, ARM, MSP430, TTL logic active low). Indication LED’s for Relay output status.
-
-
-
-
-
-
-
-
Add to cart
- Relay Boards
FR120N Mosfet control Module Replacement
- ₹84
- Model: FR120N MOS tube: 100V 9.4A Dimensions: 23mm X 16mm Mounting Holes Diameter: 2mm Compatible with MCU and control board, 3V or 5V signal. High-level start, low-level stop, PWM speed regulation.
-
-
-
-
-
-
-
-
Add to cart
- Electronic Modules and Displays, Relay Boards
8 Channel Isolated 5V 10A Relay Module opto coupler For Arduino PIC AVR DSP ARM
- ₹349
- Channel: 8 channel Relay Operating Voltage: 5V One normally closed contact and one normally open contact Triode drive, increasing relay coil High impedance controller pin Pull-down circuit for the avoidance of malfunction Power supply indicator and Control indicator lamp Power supply and relay instructions, lit, the disconnect is off;
-
-
-
-
-
-
-
Add to cart
- Electronic Modules and Displays, Relay Boards
Single Channel 5V Relay Module without Optocoupler
- ₹42
- High quality relay used 1-Channel Relay interface board Equipped with high-current relay : 12A @ 125V or 10AA @ 250V A Standard interface that can be controlled directly by microcontroller (Arduino , 8051, AVR, PIC, DSP, ARM)
-
-