2 sine wave and 2 square wave output. AD9850: 0-40MHz. After the 20-30MHz frequency harmonics increases, the waveform will be less and less clean. Low-pass filter with 70MHz, so the waveform better than SN. Parallel and serial data input can be selected via a jumper.
Working voltage: + 12V ~ + 25V Can output triangular wave, rectangular wave and sine wave. Frequency range: 10HZ ~ 300kHz Low distortion sine wave: 1% Duty ratio range: 2% to 98%
Absolutely Open Hardware Rising/falling edge trigger Compact rectangular housing Large display screen Buttons on the side Mini pocket-sized Compact and lightweight Store file as BMP, DAT, BUF, or CSV format Use built-in flash disk to save/read waveform image Math waveforms: DATA, -DATA, Inp+D, Inp-D, -Inp Output test signal: 10Hz??1MHz (1-2-5 sequence step) Synchronous mode: auto, normal, single, none, scan
Absolutely Open Hardware Rising/falling edge trigger Compact rectangular housing Large display screen Buttons on the side Mini pocket-sized Compact and lightweight Store file as BMP, DAT, BUF, or CSV format Use built-in flash disk to save/read waveform image Math waveforms: DATA, -DATA, Inp+D, Inp-D, -Inp Output test signal: 10Hz??1MHz (1-2-5 sequence step) Synchronous mode: auto, normal, single, none, scan
This kit uses ARM Cortex-M3 processor (STM32F103C8), and includes a 2.4-inch color TFT display screen. Adjustable vertical displacement, and with instructions. With automatic, regular and one-shot modes, easy to capture the moment waveform. Available rising or falling edge trigger. Observable previous trigger waveform (negative delay). Can freeze at any time waveform display (the HOLD function). Maximum Real-time Sampling Rate: 1Msps…
5V single power supply. Wave frequency adjustable 0-400Hz adjustable frequency pure sine wave. Unipolar and bipolar modulation mode. External 12MHz crystal oscillator. PWM carrier frequency 23.4KHz. Voltage, current, temperature feedback real-time processing. Overvoltage, Undervoltage, overcurrent, overheating protection function. Pin set soft-start mode 1S response time. Serial communication to set the output voltage, frequency and other parameters.
200/100/70MHz bandwidth selections, 2ch input 100/70/50MHz bandwidth selections, 4ch input 1GSa/s maximum sampling rate 10M maximum memory depth for each channel 7?? 800 x 480 WVGA LCD display 256 color gradient display function to strengthen waveform performance 1Mpts FFT frequency domain signal display Zero Key function for horizontal time, vertical voltage and triggering Compact and innovative exterior design
2.3 V to 5.5 V power supply Digitally programmable frequency and phase 0 MHz to 12.5 MHz output frequency range 28-bit resolution: 0.1 Hz at 25 MHz reference clock Sinusoidal, triangular, and square wave outputs 3-wire SPI interface
