Description

This is MCP2515 CAN Module TJA1050 Receiver SPI 51 Single Chip Program Routine Arduino with this module, you will find easy to control any CAN Bus device by SPI interface with your MCU, such as Arduino UNO and Compatible with Arduino based micro-controller projects.
Pin Definitions

VCC 5V power input pin
GND power ground pin
CS SPI SLAVE select pin (Active Pin)
SO SPI master output slave input pin
SCLK SPI clock pin
INT MCP2515 interrupt pin

Interface

J1 120R resistor terminal selection
J2 CANH, CANL KF301-2P block output
J3 CANH, CANL pin output

Schematic of?MCP2515 CAN Module TJA1050 Receiver SPI 51

Features :

Support CAN V2.0B technical standard, communication rate 1Mb / S.
0 to 8 bytes long data field.
Use High-speed CAN transceiver TJA1050
SPI control for expanding Multi CAN bus interface
Use serial port could view the communication data
With the independent key, LED indicator, Power indicator
With power pin
Standard frames, extended frames, and remote frames.
Impedance matching, guaranteed drive capability, long-distance data transmission, prevent signal radiation
Positioning screw hole center spacing 23 mm x 38 mm
The working current: typical 5mA, standby current 1 microamp. Except for the power indicator.

Package Includes :
1x MCP2515 CAN Bus Module TJA1050 Receiver SPI Protocol 51 Single Chip Micro-controller Program Routine.