NEO-6M GPS Module with EPROM

287

5Hz position update rate.
The cold start time of 38 s and?Hot start time of 1 s.
Configurable from 4800 Baud to 115200 Baud rates. (default 9600).
SuperSense ? Indoor GPS: -162 dBm tracking sensitivity.
Support SBAS (WAAS, EGNOS, MSAS, GAGAN).
Separated 18 x 18mm GPS antenna.

Out of stock

SKU: 7516 Category:

Description

If you are wandering to navigate the distance with a drone then this GPS Module is needed for you. GPS drones are equipped with a GPS module that allows them to know their location relative to a network of?orbiting satellites. Connecting to signals from these satellites allows the drone to perform functions such as position hold, autonomous flight, return to home, and waypoint navigation.
This is a complete GPS module that is based on the NEO 6M GPS. This unit uses the latest technology to give the best possible positioning information and includes a larger built-in 25 x 25mm active GPS antenna with a UART TTL socket. A battery is also included so that you can obtain a GPS lock faster. This is an updated GPS module that can be used with ardupilot mega v2. This GPS module gives the best possible position information, allowing for better performance with your Ardupilot or other Multirotor control platform.
The GPS module has serial TTL output, it has four pins: TX, RX, VCC, and GND. You can download the u-center software for configuring the GPS and changing the settings and much more. It is really good software (see link below).
?NOTE: ?
NEO-6M GPS Module is not compatible with APM 2.8 Flight Controller
To Explore more GPS modules, Click here

Interfacing NEO-6M with Arduino:

?

Features:

5Hz position update rate
Operating temperature range: -40 TO 85?CUART TTL socket
EEPROM to save configuration settings
Rechargeable battery for Backup
The cold start time of 38 s and?Hot start time of 1 s
Supply voltage: 3.3 V
Configurable from 4800 Baud to 115200 Baud rates. (default 9600)
SuperSense ? Indoor GPS: -162 dBm tracking sensitivity
Support SBAS (WAAS, EGNOS, MSAS, GAGAN)
Separated 18X18mm GPS antenna

Useful Links:
For Arduino code Click here
6 GPS Receiver and Protocol Description
Onboard?M24C32-R (432RP marking) EEPROM datasheet
Onboard voltage regulator?MIC5205 (marked KB33) datasheet
Arduino NEO-6M library
To connect the Neo GPS module with Raspberry Pi Click here

Package?Includes:
1 x NEO-6M GPS Board.
1 x Detachable Antenna.

Additional information

Weight 0.016 kg
Dimensions 8 × 6 × 4 cm