Input Voltage (V): MC: 4.8V~5.5V (recommended 2S~6S Lipoly). Supported ESC Output 400 Hz refresh frequency Supported Transmitters PCM or 2.4 GHz radio with at least 4 channels Power Consumption MAX: 1.5 W (0.3 A at 5 V) Operating Temperature: -10 to 50°C
No. of Channels:6 Model type:Glider/Heli/Airlane RF range(Hz):2.4000-2.485 Bandwidth (kHz):500 Band:160 RF Power: Less Than 20 dBm Sensitivity (dBm):1024 Low Voltage Alarm: Yes (less than 9V) DSC port:Yes(PS2; output: PPM)
ATmega328P with Arduino bootloader MAX7456 monochrome on-screen display FTDI cable compatible pinout Standard 6 pin ISP header 2 independent power sections with an LED indicator on each Solder jumpers for combining the power sections Compatible flight controller: APM2.5/2.6/2.8 Pixhawk PX4
8 Channel PWM input 8 motor outputs 12-way Auxiliary input and output Supports GPS, compass, telemetry and power module Onboard connections JST-SH with 1.0mm pitch Compatible with official Firmware and Groundstation.
128Mb Flash(16M Byte) SBUS/PPM input (Pinheaders) DSM/DSM2/DSMX input(Plug) 6PWM output (Pinheaders) Only 36x36mm, mount holes 30.5×30.5mm All through hole pin header Design -no Sh connectors STM32 F405 MCU, Runs Raceflight CC3D REVO firmware Works Perfect with Raceflight or BetaFlight 3.0
Supported Receiver Input Signal: PPM, SBUS, DSM Support PPM, SBUS, DSM receiver input signal Battery voltage detection and buzzer interface Run on SP RACING F3 EVO firmware 32 brush flight control Large current NMOS transistors, operating current can reach 10A or higher Use STM32F303CCT6 + MPU6500, advanced hardware platform F3 for higher flight
CPU: STM32F030 Six-Axis: MPU6050 Firmware version: Silverware firmware Power Cable: 55mm, with JST-PH 2.0 connector ESC: All FETs are rated at 6A maximum. Support 6x15mm/7x20mm/8x20mm/8.5x20mm etc motors. Size: 26mm x 26mm, fully compatible with the Inductrix quad frame and mounting pattern
