ESP-Prog is a development and debugging tool with automatic download firmware, serial communication, JTAG online debugging, and other functions. ESP-Prog is easy to use
Microcontroller: SAMD21 Cortex-M0+ 32bit low power ARM MCU Board Power Supply (USB/VIN): 5V Supported Battery(*): Li-Po single cell, 3.7V, 700mAh minimum DC Current for 3.3V Pin: 600mA Comes with a micro SD card holder
MCU STM32H743 32-bit processor running at 480 MHz VTX ON/OFF Pit Switch ? Switch can be enabled using USER1 in the Beta flight Mode tab. H7 processor @480 MHz Bluetooth onboard 8 Motors outputs in plugs 128 MB flash for logging VTX On/Off switch
Input voltage: AC 220V?10%,50Hz Output voltage: 0 ~ 100V Output current: 0 ~ 10A Voltage resolution: 0.1V Current resolution: 0.1A Rugged and durable Constant voltage and current Protection for Overvoltage, Overcurrent, Overload, Over-temperature, & Short circuit
Power Supply Voltage: 3.3~5V Communication baud rate up to 1M bps Up to 12V-2W power output (output current is about 160mA) Isolation voltage 3000 VDC Bus electrostatic protection capacity is up to 15kV 1/8 unit load, bus load capacity up to 256 nodes
Bidirectional control for one brushed DC motor. Operating Voltage: DC 6V to 30V Maximum Motor Current: 20A continuous, 60A peak Buttons for quick testing. LEDs for motor output state. Overcurrent protection with active current limiting. Temperature protection. Undervoltage shutdown.
