Direct plug design, Works with most USB port and USB extension cable ?Low power consumption design Onboard 2×3 Pin AVR ISP port ?3pin servo connector can be used as servo or C2 connection Supports SIMONK and BLHELI ESC,?KKflashtool compatible KKflashtool and RapidFlash?compatible
Modulation type: GFSK DSC port: PPM/I-BUS/S.BUS Antenna length: 26mm(not including brass contacts) Power input: 4.0-8.4V No ground interference( transmitting and receiving 1m from the ground):?＞300m Operating current:40mA Channel delay: ＜15ms
Pack contains quality products All products are tested and ready to perform All essential equipment required to build a Racing Drone is included in this advanced combo pack.
ATmega328P with Arduino bootloader. MAX7456 monochrome on-screen display. +5V 500mA regulator for up to +12V supply input. FTDI cable compatible pinout. The standard 6-pin ISP header. Standalone, or with APM/ Flip / Flip32+ flight controllers.
Model: Mamba F4 pro V2 Input voltage: 2 ?? 6s LiPo support Gyroscope: MPU6000 (reserved external gyroscope interface) Firmware: BetaFlihgt 3.2.0 OMNIBUSF4SD Support Receiver: PPM, SBUS, IBUS, DSM2/DSMX Receiver (UART1) Integrated with OSD, support BF Ground Station adjust OSD Adjust the PID by OSD by remote control
MCU: STM32F405RGT6?32-bit processor IMU: ICM20689 (SPI) USB VCP Driver (all UARTs usable simultaneously; USB does not take up a UART) 3 hardware UARTS (UART1,3,6) 128 Mbit Dataflash chip for Blackbox logging 5v Power Out: 1.5 A max 3.3v Power Out: 200 mA max
CAN1: interface connected to K++ flight control 12V-CAN: Output voltage 12V; can be connected to ground radar, obstacle avoidance radar, RTK, etc. 12V: Output voltage 12V; interface XT30
Brand Name: HotRC Product Name: DS-600 Transmitter & Receiver Number Of Channels: 6 Spread Specturm Method: FHSS Responding Speed: PWM??20ms Frequency Range: 2.4Ghz ISM Wave Band(2.4005-2.4835Ghz) Distance: 300-500m On The Water Surface 400-600m On The Ground
