Compatible with Arduino NANO All digital and analog pins breakout Compact size. Leads all pins out, convenient for wiring and doing experiments. Dimensions: 53 x 36 x 12 (LxWxH) mm. Weight: 22 gm.
PS-2 connector Audio jack 3.5 mm connector Composite Video and Audio for RCA jacks VGA monitor connector 10 pin IO connector for Duinomite with cable A small ribbon cable with IDC10 connectors on both ends
Stable 5V powered, low current consumption, less than 150mA. 1 standard PS2 controller socket. Communicate with host microcontroller through 5V TTL?UART. Simple inquiry command and button status feedback for the host process. Vibrator motor is controllable. Wired or wireless PS2 controller is fully compatible. A small LED as the indicator for communication between SKPS and PS2 controller.
Analog Ports: include 4 anlog ports, A0, A1, A2 and A3. Digital Ports: include 7 digital ports, D2, D3, D4, D5, D6, D7 and D8. UART Port: 1 UART port. I2C Ports: 4 I2C ports.
Operating voltage: 5 V Tutorials for guidance Fully compatible with Arduino UNO High performance, low power 8 bit ATmega328 MU microcontroller Serial converter CP2102N chip (to communicate the Seeeduino with a computer by using a micro-USB cable) 2 on-board Grove connectors 14 Digital I/O Pins (6 PWM outputs) 6 Analog inputs ISP header Arduino UNO-R3 shield compatible Micro USB programming…
AD hoc IIC interface, APC220 wireless rf module communication interface RB URF v1.1 ultrasonic sensor interfaces Line 12864 LCD series and parallel interface More convenient and easy to use
The I2C input, PWM output control 16 roads, steering gear can 16 roads. The steering gear power independent V + input maximum 6 V. Logic signals and logical power independent output for 3V to 5 V. 40-1000 Hz frequency. Terminal block for power input. Reverse polarity protection on the terminal block input Green power-good LED
Stackable connectors ?? up to 6 channels can be stacked and wired to A0-A6 analogue inputs Calibration signal generation by D4/D9 digital output Precise trimmer potentiometer for calibration (all boards are shipped completely assembled, tested and calibrated so that you don??t have to do this unless you want to see how things works) Input connector for?standard?or active electrodes Works with…
Simple to use UART protocol Vibrator motor on PS2 is controllable. Wired and Wireless PS2 controller is supported. PS2 Controller will automatically operate in analog mode. (Default) A status LED Jumper selector to select different UART Baud Rate (74880 (Default), 9600, 57600, 115200). Default: ?? when no jumper is attached. Jumper selectors to select different digital pin as UART ??…
