Microcontroller: AT91SAM3X8E Operating Voltage: 3.3V Input Voltage (recommended): 7-12V Input Voltage (limits): 6-16V Flash Memory: 512 KB all available for the user applications SRAM: 96 KB (two banks: 64KB and 32KB) Clock Speed: 84 MHz
Product: Arduino Edge Control Enclosure Kit LCD display to instantly check sensor data on location Customizable push button to view different data in rotation Monitor data even when the connection is unavailable or unreliable
Operating voltage 3.3V (supplied from the host board) Two relays with?NO,?COM,?and?NC?connections Works with battery-powered board Carry current: 2 A Max. operating voltage: 24 VAC, 50 VDC
Microcontroller: SAMD21 Cortex-M0+ 32bit low power ARM MCU Board Power Supply (USB/VIN): 5V Supported Battery(*): Li-Po single cell, 3.7V, 700mAh minimum DC Current for 3.3V Pin: 600mA Comes with a micro SD card holder
ATSAMD11 ( Arm Cortex-M0+ @48 Mhz) microcontroller MP6522 motor driver Onboard 9-axis accelerometer, gyroscope, and magnetometer A battery charger for single-cell Li-ion batteries 2 ports for quadrature encoder counting A series of 3-pin male headers Easily connects actuators and sensors
Powerful processor with integrated Deep Neural Networks in a tiny form factor (22.86 x 22.86 mm) Integrated microphone, magnetometer and smart 6-axis IMU Onboard Bluetooth? Low Energy connectivity Add speech recognition capabilities to your projects
Get started with electronics quickly and easily without any prior experience because with this kit you will get an Official Arduino pictorial Project book
A 32-bit core, that allows operations on 4 bytes wide data within a single CPU clock. CPU clock at 84Mhz 96KBytes of SRAM 512KBytes of flash memory for code A DMA controller, that can relieve the CPU from doing memory intensive tasks.
Microcontroller: nRF52840 (datasheet) Radio module: u-blox NINA-W102 Secure Element ?: ATECC608A Operating Voltage: 3.3V Input Voltage (limit) : 21V DC Current per I/O Pin: 7 mA Clock Speed: 48MHz
Microcontroller: nRF52840 (datasheet) Radio module: u-blox NINA-W102 Secure Element ?: ATECC608A Operating Voltage: 3.3V Input Voltage (limit) : 21V DC Current per I/O Pin: 7 mA Clock Speed: 48MHz
Manufacturer: Arduino Officials Operating Voltage (logic level): 5V 8 analog inputs ports: A0 ~ A7 14 Digital input / output ports: TX, RX, D2 ~ D13 1 pair of TTL level serial transceiver ports RX / TX Using Atmel Atmega328P-AU MCU There is a bootloader installed in it Standard 0.1? spacing DIP (breadboard friendly). Manual reset switch.
Microcontroller: ATMEGA4809 Operating Voltage: 5V Input Voltage (recommended): 7-12V Digital I/O Pins: 14 (6 Provide PWM Output) PWM Digital I/O Pins: 6 Analog Input Pins: 6 DC Current per I/O Pin: 20mA DC Current for 3.3V Pin: 50mA Flash Memory: 48KB (ATMEGA4809) SRAM: 6,144KB (ATMEGA4809) EEPROM: 256 Bytes (ATMEGA4809) Clock Speed: 16MHz
