Analog Ports: include 4 anlog ports, A0, A1, A2 and A3. Digital Ports: include 7 digital ports, D2, D3, D4, D5, D6, D7 and D8. UART Port: 1 UART port. I2C Ports: 4 I2C ports.
Operating voltage: 5 V Tutorials for guidance Fully compatible with Arduino UNO High performance, low power 8 bit ATmega328 MU microcontroller Serial converter CP2102N chip (to communicate the Seeeduino with a computer by using a micro-USB cable) 2 on-board Grove connectors 14 Digital I/O Pins (6 PWM outputs) 6 Analog inputs ISP header Arduino UNO-R3 shield compatible Micro USB programming…
Supports Wi-Fi, USB host and SD cards Pin-out for PWM, I2C, SPI, UART, Ethernet, and I2S Open hardware board reference design including schematics, layouts and pin details Single input single output (1T1R) Wi-Fi 802.11 b/g/n. Pin-out for GPIO, I2C, I2S, SPI, UART, PWM and Ethernet Port. 580 MHz MIPS CPU. 32MB Flash and 128MB DDR2 RAM. USB host. Micro SD…
ATmega328P microcontroller Arduino UNO bootloader 14 Digital I/O Pins (6 PWM outputs) 6 Analog Inputs ISP Header Arduino UNO-R3 Shield Compatible Micro USB programming and power supply 3 on-board Grove connectors 3.3/5V system operation power switch
AD hoc IIC interface, APC220 wireless rf module communication interface RB URF v1.1 ultrasonic sensor interfaces Line 12864 LCD series and parallel interface More convenient and easy to use
Retain the merits of the V4.0 version Laminated design PCB immersion gold processing technology IIC interface Bluetooth module communication interface SD card module communication interface APC220 wireless rf modules communication interface RB URF v1.1 ultrasonic sensors interface 12864 LCD string of line and parallel interface 32 servo controller interface
The I2C input, PWM output control 16 roads, steering gear can 16 roads. The steering gear power independent V + input maximum 6 V. Logic signals and logical power independent output for 3V to 5 V. 40-1000 Hz frequency. Terminal block for power input. Reverse polarity protection on the terminal block input Green power-good LED
Stackable connectors ?? up to 6 channels can be stacked and wired to A0-A6 analogue inputs Calibration signal generation by D4/D9 digital output Precise trimmer potentiometer for calibration (all boards are shipped completely assembled, tested and calibrated so that you don??t have to do this unless you want to see how things works) Input connector for?standard?or active electrodes Works with…
