Support the most popular programming PIC chips, read, encryption and other features! No external power supply, communication, and power is only a USB cable to print complete, without any cable. PICSTARTPLUS much faster rate than programming. Can easily read the contents of the chip program area. Automatic programming verification. Comprehensive information prompts, allowing users to understand the working state.
Model: STM32F302R8T6 MCU Voltage: 3.3V, 5V, 7-12V Two push buttons for user and reset Three interfaces supported on USB. Virtual Com port, Mass storage and Debug port STM32 comprehensive software HAL library Supported by Integrated Development Environments (IDEs) including IAR, Keil, GCC based IDEs
USB VBUS or external source (3.3V, 5V, 7 to 12V) and power management access point USB communication (LD1), user LED (LD2), power LED (LD3) Two push buttons ?? USER and RESET USB re-enumeration capability ?? virtual com port, mass storage, debug port Supported by wide choice of IDEs including IAR, Keil, GCC-based IDEs
Model: STM32L432KC MCU Flexible power-supply options: ST-LINK, USB VBUS or external sources On-board ST-LINK debugger/programmer with USB re-enumeration capability: mass storage, Virtual COM port and debug port STM32 microcontroller in 32-pin package
1.54 inch 240×240 pixel TFT color LCD with parallel interface and capacitive touchscreen I2S Audio CODEC, with a stereo headset jack, including analog microphone input and a loudspeaker output Stereo digital MEMS microphones MicroSD??card connector extension I2C extension connector 128 Mbit Quad-SPI Nor Flash
Support a wide range of chips: All kinds of 26, 27, 28, 29, 37, 39, 49, 50 parallel ROM, EPROM, EEPROM; 24, 25, 35, 85, 93, 95 Series EEPROM, Serial parallel ROM chips; Fully supporting to the 48-PIN chips of 64Mbits capacity; It also supports a variety of models of 51 series of microcontroller, AVR microcontroller, including ATMEGA series, ATtiny…
