DIP 3 Color LED Module
₹117
- The use of plug-in full-color LED.
- RGB trichromatic limiting resistor to prevent burnout.
- Through the PWM adjusting, three primary colors can be mixed to obtain different colors.
- With a variety of single-chip interface.
- The working voltage: 5V.
- LED drive mode: common cathode driver
Description
Product Description
This module consists of a 5mm RGB LED and three 150Ω limiting resistors to prevent burnout. Adjusting the PWM signal on each colour pin will result in different colours.
This is a DIP 3 Color LED Module. Through the PWM adjusting, three primary colours can be mixed to obtain different colours.
Connect the red pin (R) on the KY-016 to pin 11 on the Arduino. Blue (B) to pin 10, green (G) to pin 9 and ground (-) to GND. Notice that you do not need to use limiting resistors since they are already included on the board.
Connection Diagram:
Pin Connection with Arduino:
| LED module | Arduino |
| R | Pin 11 |
| B | Pin 10 |
| G | Pin 9 |
| – | GND |
Features
- The use of plug-in full-colour LED.
- RGB trichromatic limiting resistor to prevent burnout.
- With a variety of single-chip interface.
- Through the PWM adjusting, three primary colours can be mixed to obtain different colours
- The working voltage: 5V
Package Includes
- 1 x RGB 3 Color LED Module.
Additional information
| Weight | 0.01 kg |
|---|---|
| Dimensions | 3 × 2 × 1 cm |
