“Q250 Quadcopter Super Strong Carbon Fiber 4mm Arm FPV Racing Frame(250mm) Kit” has been added to your cart. View cart
-
- Out of StockRead more
- Flight controllers
F3 Brushed Flight Control Board Based On SP RACING F3 EVO Brush for Micro FPV Frame
- ₹924
- Supported Receiver Input Signal: PPM, SBUS, DSM Support PPM, SBUS, DSM receiver input signal Battery voltage detection and buzzer interface Run on SP RACING F3 EVO firmware 32 brush flight control Large current NMOS transistors, operating current can reach 10A or higher Use STM32F303CCT6 + MPU6500, advanced hardware platform F3 for higher flight
-
-
-
-
-
-
- Out of StockRead more
- Flight controllers
Whoop Lite F3 Mini Brushed Flight Controller
- ₹745
- CPU: STM32F030 Six-Axis: MPU6050 Firmware version: Silverware firmware Power Cable: 55mm, with JST-PH 2.0 connector ESC: All FETs are rated at 6A maximum. Support 6x15mm/7x20mm/8x20mm/8.5x20mm etc motors. Size: 26mm x 26mm, fully compatible with the Inductrix quad frame and mounting pattern
-
-
-
-
-
-
-
- Out of StockRead more
- Flight controllers
Pixhawk-Radiolink
- ₹16,525
- 32bit STM32F427 Cortex M4 core with FPU 168MHz 256KB RAM 2 MB Flash
-
-
-
- Out of StockRead more
- Flight controllers
Matek MateksysF411-WSE Compact Flight Controller
- ₹5,177
- MCU: 100MHz STM32F411CEU6 IMU: MPU6000 (SPI) Continuous current: 3.5 Amps Input voltage range: 6~30V Compatible lipo: (2~6S LiPo)
-
-
-
-
-
-
- Out of StockRead more
- Flight controllers
F4 V3S Plus Flight Control OSD 2-6S Two way 3A BEC 9V Pad Design For Betaflight RC FPV Racing Drone Quadcopter Frame
- ₹3,195
- Item name: F4 V3 PLUS Flight Controller Firmware: Omnibus ~ f4 Board Dimensions: 36x36mm Montagegaten: 30.5×30.5mm STM32 F405 MCU Dshot protocol
-
-
-
-
-
-
-
- Out of StockRead more
- Flight controllers
NX4 EVO Flight Controller for RC Airplane Aircraft
- ₹1,610
- Input voltage: 5 – 6V(DC). Operating Current: 18mA. Net Weight: 11 g. This Controller can be connected to ESC’s with BEC.
-
-
-
-
-
-
-
-
Add to cart
- Drone Frames
Quadcopter Drone Frame F450
- ₹719
- Width: 450mm Height: 55mm Weight: 270g (w/out electronics) Motor Mount Bolt Holes: 16/19mm
-
-
-
-
-
-
-
-
Add to cart
- Drone Frames
Q250 Quadcopter Super Strong Carbon Fiber 4mm Arm FPV Racing Frame(250mm) Kit
- ₹1,270
- Wheelbase: 250mm Material: Full Carbon Fiber Weight: 160 gm The arm equips dampers for the safe landing. The arm has multiple motor mounting holes. Equips vibration-free mounting bracket for FPV camera.
-
-
-
-
-
-
-
- Out of StockRead more
- Chargers & Adapters, Drone Parts
SKYRC PC520 520W 20A LiPo Charger for Drones
- ₹9,745
- Supports 6s LiPo battery Adjustable charge current from 1.0 to 20.0A The charger can store the charge current of the last charge program LED digits on indicate charge/discharge status Two working modes: balance charge mode and storage mode
-
-
-
-
-
-
- Out of StockRead more
- Flight controllers
Naze 32 Full REV6 Flight Controller with Compass & Barometer
- ₹1,482
- 2000 degrees/second 3-axis MEMS gyro + accelerometer (MPU6500). Input voltage: Max 16V on input rail and up to 35V 6s on the voltage sense line. Fully pinout compatible with rev5 accessories (OSDoge etc). SBUS Inverter. Sonar pads w/resistors added for direct connection to 5V sonar. MS5611 barometer. 128mbit flash.
-
-
-
-
-
-
-
- Out of StockRead more
- Flight controllers
OpenPilot CC3D EVO Flight Controller Straight Pin
- ₹1,440
- 3-axis high-performance MEMs gyros and 3-axis high-performance MEMs accelerometer. Tiny 36 x 36 mm 4 layer PCB for superior electrical noise reduction and flight performance. Software support for Windows, Mac, and Linux. Direct high-speed USB support with no drivers required, a true plug and play device. Spektrum satellite receiver support. Futaba S-BUS hardware support. Innovative Flexi-port technology for superior port flexibility. 4Mbits onboard EEPROM for configuration storage.
-
-
-
-
-
- Out of StockRead more
- Flight controllers
CC3D Flight Controller Mini Power Distribution Board PCB
- ₹213
- Compact body design. High quality and durable performance. Light and portable to carry. Same size and hole, where CC3D. Integrated 2 switch control LED and FPV equipment. Element type: power distribution Board Use: for CC3D flight power controller distribute The same size and hole location as CC3D
-
-
-
-
-