“Wireless Transmitter 915Mhz, Lora Shield for Leonardo, UNO, Mega2560, Duemilanove, Due” has been added to your cart. View cart
-
- Out of StockRead more
- LORA WiFi
LoRa 433MHZ SX1278 SX1276 Wireless Transmitter and Receiver RF Module 8000M E32-433T30D1B UART
- ₹1,186
- Model Number: E32-433T30D1B Port Number: 1 Type: CDMA Working Frequency: 433 MHz RF connector: SMA-K Distance: 8000m RF IC: SX1278 SX1276
-
-
-
-
Add to cart
- LORA WiFi
LoRa-E5 Development Kit
- ₹2,093
- Voltage supply: 3-5V (Battery) / 5V(USB Type C) Voltage output: EN 3V3 / 5V Power output Up to +20.8dBm at 3.3V Frequency: 865 Protocol: LoRaWAN Sensitivity: -116.5dBm ~ -136dBm
-
-
-
-
-
-
-
Add to cart
- LORA WiFi
Ai-Thinker LoRa Ra-01S
- ₹313
- Package: SMD16 Size: 17 x 16 x 3.2(±0.2)MM Antenna: Compatible with half-hole pads/through-hole pads (need tosolder the antenna)/IPEX socket Spectrum range: 410MHz~525MHz
-
-
-
-
-
Add to cart
- LORA WiFi
RFM69HCW Wireless Receiving Module 868mhz
- ₹311
- Model: RFM69HCW Frequency:868MHz Power Output Capability:+20 dBm 100 mW Sensitivity:-120 dBm at 1.2 kbps Selectivity:16-tap FIR Channel Filter FSK Bit rates:1.2kbps to 300kbps Voltage range:1.8V to 3.6V Module Size:16X16mm
-
-
-
-
Add to cart
- LORA WiFi
RFM95W Wireless Receiving Module，915mhz
- ₹650
- Input Voltage:3 V Bit Rate:300 kbps Sensitivity :Down to -144 dBm Dimension:16x16x2 mm Weight:3 gm
-
-
-
-
-
-
-
Add to cart
- LORA WiFi
SeeedStudio Grove LoRa Radio 868MHz
- ₹1,694
- Using RFM95 module based on SX1276 LoRa® Communication Interface: UART Simple wire antenna or MHF Connector for external high gain antenna +20dBm – 100 mW Power Output Capability
-
-
-
-
-
-
-
-
Add to cart
- LORA WiFi
SeeedStudio Grove LoRa Radio 433MHz
- ₹1,448
- Using RFM95 module based on SX1276 LoRa® ~28mA(Avg) @+20dBm continuous transmit ~8.4mA(Avg)@standby mode ~20mA(Avg) @receive mode, BW-500kHz Simple wire antenna or MHF Connector for external high gain antenna +20dBm – 100 mW Power Output Capability
-
-
-
-
-
-
-
-
Add to cart
- LORA WiFi
LoRa Shield for Arduino V95
- ₹3,050
- Compatible with 3.3v or 5v I/O Arduino Board. Frequency Band: 915MHz/868 MHZ/433 MHZ (Pre-configure in a factory) Low power consumption Compatible with Arduino Leonardo, Uno, Mega, DUE External Antenna via I-Pex connector
-
-
-
-
-
-
Sale!
Add to cart
- LORA WiFi
ESP32 LoRa SX1278 0.96 Inch Blue OLED Display BT WiFi Module for Arduino
- Original price was: ₹2,499.₹2,099Current price is: ₹2,099.
- Supports Sniffer, Station, softAP and Wi-Fi Direct modes Data rate: 150 Mbps @ 11n HT40,72 Mbps @ 11n HT20,54 Mbps @ 11g, 11 Mbps @ 11b Transmit power: 19.5 dBm @ 11b, 16.5 dBm @ 11g, 15.5 dBm @ 11n Receiver sensitivity up to – 98 dBm UDP continues to throughput by 135 Mbps
-
-
-
-
-
-
Sale!
-
-
Add to cart
- LORA WiFi
Wireless Transmitter 915Mhz, Lora Shield for Leonardo, UNO, Mega2560, Duemilanove, Due
- ₹2,423
- 168 dB maximum link budget. +20 dBm – 100 mW constant RF output vs. +14 dBm high-efficiency PA. Programmable bit rate up to 300 kbps. High sensitivity: down to -148 dBm. Bullet-proof front end: IIP3 = -12.5 dBm. Excellent blocking immunity. Low RX current of 10.3 mA, 200 nA register retention. Fully integrated synthesizer with a resolution of 61 Hz.…
-
-
-
-
-
-
-
-
Add to cart
- LORA WiFi
Wireless Transmitter 433Mhz, Lora Shield for Leonardo, UNO, Mega2560, Duemilanove, Due
- ₹2,423
- Compatible with 3.3v or 5v I/O Arduino Board. Frequency Band: 433 MHZ (Pre-configure in factory) Low power consumption Compatible with Arduino Leonardo, Uno, Mega2560, DUE External Antenna via SMA Jack
-
-
-
-
-
-
Add to cart
- LORA WiFi
TTGO T8 V1.7 ESP32-WROVER 8MB PSRAM TF CARD 3D ANTENNA WiFi & Bluetooth Module Micro-Python
- ₹1,685
- Lastest ESP32 Version: REV1 Connectivity: WIFI & Bluetooth Memory: 4MB Flash4MB PSRAM Lithium battery interface, 500mA Max charging current Onboard TF CARD Slot Default firmware: Latest Micropython firmware
-
-
-
-
-
-