Clean, good waveform driving ability, more than 15mA. Working voltage 3.3V-5 Output format: digital switching output (0 and 1) AÂ fixed bolt holes for easy installation
Main chip: LM393 Working voltage: for DC 5V Single-channel signal output Low-level output signal used for human body touch sensor alarm Adjustable sensitivity Pin Connector to board: 4 Pins
Operating Voltage: 3.3V-5V Features wide range voltage comparator LM393 Adjustable sensitivity Signal output indicator with the retaining bolt hole, convenient installation Output form digital switch output (0 and 1 high and low level) The output effective signal is low level When there is sound, outputs low level and the signal light
The use of plug-in full-color LED. RGB trichromatic limiting resistor to prevent burnout. Through the PWM adjusting, three primary colors can be mixed to obtain different colors. With a variety of single-chip interface. The working voltage: 5V. LED drive mode: common cathode driver
Support the most popular programming PIC chips, read, encryption and other features! No external power supply, communication, and power is only a USB cable to print complete, without any cable. PICSTARTPLUS much faster rate than programming. Can easily read the contents of the chip program area. Automatic programming verification. Comprehensive information prompts, allowing users to understand the working state.
Microcontroller: ATmega328P Circuit Operating Voltage: 5V Clock frequency: 16MHz. 6 PWM port: D3, D5, D6, D9, D10, D11. Use For Atmel Atmega328P-AU microcontroller. Support serial download. Support 9V battery. A pair of TTL level serial port transceiver : RX / TX.
Support for the Arduino IDE 1.0 + (OSX/Windows/Linux). Power via USB or External Source or 7-16 v to 5 v (automatic selection). The Onboard, 150 ma 5 v Regulator. Built-in USB and serial were debugging). 6 I/O Pins (2 inform the for USB only if your program actively communicates over USB, otherwise you can use all 6 even if you…
Microcontroller CH340 Operating Voltage 5V Input Voltage (recommended) 7-12V Input Voltage (limits) 6-20V Digital I/O Pins 54 (of which 15 provide PWM output) Analog Input Pins 16 DC Current per I/O Pin 40 mA Dimensions : 111 x 54 x 12 (LxWxH) mm.
Module Size: 42.7mm x 40.4mm x 4mm Easy to change mode: with a small SMD toggle Switch, it becomes very easy to change among IIC, SPI and HSU modes Longer distance: the reading distance becomes 5~7cm, compared with 4~6 cm of last version Built in PCB Antenna, with 5cm~7cm communication distance On-board level shifter, Standard 5V TTL for I2C and…
