1. DC-INPUT： supply voltage (DC3.0V～12V) 2. TEST: test pin for output. With output, high level signal (3.0V); no output, low level signal (0V) 3. LOAD+: anode of the load. LOAD-: cathode of the load. The voltage of the load and. DC-INPUT are the same. The Max current with load is 100mA. 4. DARK_ADJ：Lux adjustment. 5. DELAY_TIME: delay time adjustment.
Support motor voltage from 7V to 22V. Onboard Low, Internal resistance MOSFETs are switched at 16 KHz frequency. Overcurrent and Thermal protection. Multiple input modes: RC, Analog, PWM, Serial Packetized. On-board push buttons for test and manual operation. Type-C USB for SERIAL Mode
Input Voltage: 4.5V ~ 5.5V. Input Interface: 5VDC Micro USB and DC JACK input. On-board Battery compatible: ?? 18650 Li-ion cell. Charge Current: up to 1A. Over-voltage detection: 4.2V. Under-voltage detection: 2.8V. Output Interface: ?? 2 Pin Connector with a properly marked positive and negative signs on PCB. LED indicator: Input Power status/ Charging /Charge complete / Battery detects /…
Supplying 30 amps continuously with peak currents up to 85 amps (2 Sec) per channel. Support motor voltage from 7V to 28V. Onboard Low Internal resistance MOSFETs are switched at? 16KHz frequency. Overcurrent protection and indication. Thermal protection. Type-C USB for SERIAL Mode
Onboard 5V regulator (78M05) circuit. On-Board power supply on-off switch On-Board DC motor Driver L298P On-Board 4×4 Matrix Keypad. On-Board 4 bit 16×2 LCD Display. 0592MHz crystal. Port extensions for all ports with detailed pin labelling for easy identification of pins Onboard USB TO Serial ?? CH340 Chip. On-board Micro USB USBASP for loading HEX file.
Microcontroller: ATMEGA2560 with 16 MHz crystal with On-Board USBASP Programmer. Power: 7 to 15 VDC with Reverse Polarity Protection. 2.4GHz ZigBee (XBee) wireless module adaptor 2×16 Character Alphanumeric LCD. SD card Holder. CH340G USB to Serial converter. ESP8255 Adaptor interface with USB to Serial Converter.
Recommended Input Voltage: 12V Input Voltage Range: 5-15V 2 Pin 2mm SMD JST Right-angle Connector for Input supply On-board TPS62133RGTT Synchronous step down DC-DC converter. Power Status LED (RED) Micro USB for Communication with Android. One start LED connected to boot pin (RC12 =Pin no. 39). User Switch SW1, SW2 connected to any port pin through SW1, SW2 Jumper respectively.
Simple to use UART protocol Vibrator motor on PS2 is controllable. Wired and Wireless PS2 controller is supported. PS2 Controller will automatically operate in analog mode. (Default) A status LED Jumper selector to select different UART Baud Rate (74880 (Default), 9600, 57600, 115200). Default: ?? when no jumper is attached. Jumper selectors to select different digital pin as UART ??…
Operating Voltage Range: 9~12V Maximum Operating Current: 130 mA Optimal Sensing Distance: 0.125″ (3 mm). Fast response time High sensitivity 5 Analog and 5 Digital Output signals with Respective LED. Each IR has indicating LED (D0-D4). Available SPI and Serial communication Pins.
