Input Voltage : 2 Volt – 5.5 Volts DC. The response time max ~ 60mS in fast mode, ~220mS at low power mode @VDD=3V. Sensitivity can adjust by the capacitance(0~50pF). Stable touching detection of the human body for replacing traditional direct switch key. Provides direct mode toggle mode by pad option(TOG pin). After power-on have about 0.5sec stable-time, during the…
Portable- The solar panel is thin and extremely lightweight, making them ideal for use in portable projects. IP65 Water-proof Solar Panel- Environmental and water-proof solar panel with long-lasting material provides a long lifespan. Eco-friendly-A solar panel will lower the costs on your power bill and help curb your carbon emissions. High Conversion Efficiency-Highly efficient solar cells convert up to 19.5%…
Supply Voltage Min: 4.5V Supply Voltage Max: 16V Timing from microseconds to hours A stable or monostable operation Adjustable duty cycle TTL compatible output can sink or source up to 200mA
3mm?Round Water Clear?LED?Lamp For?LED?light, indication, illumination Viewing angle: 40 degree UV resistant epoxy With lowest power consumption, long life, and super bright
Plate Thickness: 0.42mm Diameter: 35mm Sound pressure level: 85DB 10cm The input voltage: 30vp-p max Clear sound Ultra-thin and lightweight No contacts: therefore, no noise and highly reliable
5mm?Round Water Clear?LED?Lamp For?LED?light, indication, illumination Viewing angle: 40 degree UV resistant epoxy With lowest power consumption, long life, and super bright
5mm?Round Water Clear?LED?Lamp For?LED?light, indication, illumination Viewing angle: 40 degree UV resistant epoxy With lowest power consumption, long life, and super bright
5mm?Round Water Clear?LED?Lamp For?LED?light, indication, illumination Viewing angle: 40 degree UV resistant epoxy With lowest power consumption, long life, and super bright
Dual ARM Cortex-M0+ @ 133MHz 264kB on-chip SRAM in six independent banks Support for up to 16MB of off-chip Flash memory via dedicated QSPI bus DMA controller Fully-connected AHB crossbar Interpolator and integer divider peripherals On-chip programmable LDO to generate the core voltage 2 on-chip PLLs to generate USB and core clocks 30 GPIO pins, 4 of which can be…
Overtemperature Protection Logical ?0? Input Voltage Up To 1.5 V (High Noise Immunity) Internal Clamp Diodes. Featuring Unit rode L293 and L293D Wide Supply-Voltage Range: 4.5 V to 36 V Separate Input-Logic Supply Internal ESD Protection Thermal Shutdown High-Noise-Immunity Inputs
400 tie points 2 Power lanes, Total 100 tie points in power lanes 1 Double strip, Total 300 tie points Perfect for Arduino shield prototyping and testing Plastic housing, metal contact clips
Supported Hard Drives M.2 SATA channel Solid State Drive Transfer interface Support PCIe X1/X4/X8/X16 Operating system Windows / Linux Dimensions 100.0 × 55.0mm
PCIe TO 4-Ch SATA 3.0 Expander. 6Gpbs High-Speed SATA Interface. Supports CM4 .Onboard SATA host controller (AHCI). PCle Gen3 x1 and downstream four SATA Gen3 ports.
Supported Hard Drives: HDD and Solid State Drive with SATA protocol compatible Transfer interface: SATA female port × 5, M.2 B-key SATA male port × 1 Transfer speed SATA3: 6Gbps Operating system: Windows / Linux Dimensions: 80.0 × 22.0mm
Supports 2.4G/5GHz dual-band, the speed up to 300Mbps in the 2.4GHz band and 867Mbps in the 5GHz band Supports Bluetooth 5.0 standard, compatible with Bluetooth 2.1+EDR Adopts NGFF (M.2 A/E Key) interface
Product: Gigabit PoE Splitter 5V 3A, 2-in- 1 PoE to USB C/ Micro USB Adapter Operating Power: DC38~57V IEEE 802.3af/at PoE Output Power(Watt):? 15 Data Output Port: RJ45 Male Power Output Ports: ?Micro USB male port; Micro USB female to USB-C male port.
Product Type: Microcontroler Model: STM32L073RZT6 power supply: 1.65 V to 3.6 V ?temperature range: 40 to 125 ?C Core: Arm 32-bit Cortex-M0+ with MPU Core frequnency: 32 kHz up to 32 MHz max
Power supply: 1.65 V to 3.6 V ?Temperature range: -40 to 125 ?C Arm 32-bit Cortex-M0+ Frequency: 32 kHz up to 32 MHz max. Clock sources: ?? 1 to 25 MHz crystal oscillator
Operating Voltage: 2.0 to 3.6 V Number of Pins: 64 Frequency: 48 MHz Interface: HDMI, I2C, I2S, IrDA, LIN, SPI, UART, USART Operating Temperature: -40 to +85 C
Characteristic impedance: 50?2 Ohms Frequency range: DC-1GHz Insertion Loss : 1.64 dB max @ 1GHz & 20?C Operating temperature range: -40?C to +85?C It? Supports High Bandwidth Levels. This cable is Easy to Install. The cable is Easy to Locate.
Product: Power Inductors Type: Toroidal Termination Style: Radial Package/Case: 24.64 mm x 15.5 mm x 27.94 mm Shielding: Unshielded Inductance: 100 uH Tolerance: 20 %
Base Material: FR4. Type-C 6Pin Contact?resistance:?30mΩ Max. Micro USB Connector Socket Jack For MP3/4/5 Insulation?resistance:?100?MΩ min. Dielectric?strength:?500VAC?one?min. Insulator?material:?LCP.
Multiprotocol 2.4GHz radio 32-bit ARM Cortex M0 processor 256kB/128kB flash and 32kB/16kB RAM 10-bit ADC 128-bit AES ECB/CCM/AAR co-processor Quadrature demodulator Low cost external crystal 16MHz ? 40ppm Low power 16MHz crystal and RC oscillators Ultra low power 32kHz crystal and RC oscillators Wide supply voltage range (1.8 V to 3.6 V)
Product: HR10A-7P-6S(73)-PLUG, SOCKET CNTS, PUSH-PULL, Male Terminal Material: Silver or gold plated brass/bronze Female Terminal Material: beryllium/phosphor bronze Number of contacts: varies from 4 to 20
Rated current: 6A 250 V a.c. Insulation resistance: 100 MΩ (500 V d.c.) Dielectric strength: 2,000Va.c. for 1 minute (Between the charging part and non-charging part) Protection rating: IP65 (EC 60529) Materials case: High impact resistance ABS resin
Decibel: 98dB Max. Power supply voltage: 12, 24 V DC (HY-606MD) Power frequency: 50/60 Hz Power consumption: Approx 2.5 W Installation hole: Ø66 panel cutout
Component inclosed in Plastic Box with Lock All essential component for workbench 300 point breadboard with a jumper cable U 103 Potentiometer and may other components included
This Kit comes with all Advance components and one Acrylic plate and servo motor. Find all the component and their quantity details in description below
Compact Design: The FeatherWing is designed to be small and lightweight, making it easy to integrate into your Feather-based projects without taking up much space. Relay Control: It provides two non-latching relays, allowing you to control high-voltage and high-current devices with your Feather board. Compatibility: Designed to work seamlessly with Adafruit Feather boards, ensuring a plug-and-play experience with Feather-based projects.
3mm?Round Water Clear?LED?Lamp For?LED?light, indication, illumination Viewing angle: 40 degree UV resistant epoxy With lowest power consumption, long life, and super bright
Part Number: 2316-V-RC 1945 Series: 2300 Inductance Frequencyt: 1 kHz Mounting Type: Through Hole Mounting Type: Radial Maximum DC Current: 5 A Tolerance: ?15%
Part Number: 2200HT-220-V-RC 2115 Series: 22HT00 Inductance Frequencyt: 1 kHz Mounting Type: Through Hole Mounting Type: Radial Maximum DC Current: 5 A Tolerance: ?15%
Part Number: 2100HT-101-V-RC 2111 Series: 2100HT Inductance Frequencyt: 1 kHz Mounting Type: Through Hole Mounting Type: Radial Maximum DC Current: 5 A Tolerance: ?15%
Number of Pins: 40 Pin Spacing(pitch): 2.54 mm Length of the Strip: 103 mm Pin height: 6 mm Square Posts. Stackable – End to End and Side to side. Can be manually broken for the length needed. Standoffs allow cleaning of solder contaminants.
Widely used in small-scale as well as prototyping projects where 12 to 30 volts power supply needed Supports DC Power Jack: 2.1 x 5.5 mm Diameter: 14mm
Internal filter for PCM frequency. Inner shield, good anti-interference ability. High immunity against ambient light. Improved shielding against electric field disturbance 3.0V or 5.0V supply voltage; low power consumption. TTL and CMOS compatibility. Suitable transmission code:NEC code,RC5 code. Universal receiver. 38 KHz. Infrared remote control receiver.
Our Welfix DE Soldering Paste Flux 15g is the perfect solution for ensuring a strong, reliable solder joint. This high-quality soldering paste flux is designed to enhance the soldering process by removing any oxide layers on the surface of the metal, improving the flow of the solder, and promoting adhesion.
High Purity Alloy: Crafted from a high-grade alloy for superior conductivity and reliable joints. Flux-Core Technology: Ensures clean, smooth soldering with minimal residue for precise work. 10gm Quantity: Perfect for smaller projects, offering just the right amount for your needs. Robust Conductivity: Delivers excellent electrical and thermal conductivity for efficient soldering.
BC557 Transistor can be used as Amplifier BC557 Transistor can be used as a switch Responsive to current Output impedance is less Life span is good Noise operation is less Circuit design is simple Uses less power supply Quick action at the circuit
Fixed Output Voltage: 5V Output Current: 0.5A Dropout Voltage: 2V Maximum DC input Voltage: 35V Output Transition SOA Protection Output Voltage Tolerance: 4% Operating Temperature Range: 0°C to 125°C
The use of plug-in full-color LED. RGB trichromatic limiting resistor to prevent burnout. Through the PWM adjusting, three primary colors can be mixed to obtain different colors. With a variety of single-chip interface. The working voltage: 5V. LED drive mode: common cathode driver
Working models of science projects kits Solar panel for science experiment kit to make working models / projects Solar power experiments solar connect with wire it is a 70 x 70 x 3mm square shape solar
BC557 Transistor can be used as Amplifier BC557 Transistor can be used as a switch Responsive to current Output impedance is less Life span is good Noise operation is less Circuit design is simple Uses less power supply Quick action at the circuit
Rating: Max 3A up to 250VAC Toggle Mode: ON-OFF Structure: SPST Shape: Round Panel Cut-Out: 15 x 13 (Dia x Height) mm Overall Dimensions: 16.3 x 15 (D x H)
Rating: Max 6A at 250VAC and 10A at 125V Toggle Mode: ON-OFF Structure: SPST Panel Cut-Out: 18.5 x 13 mm Material: Plastic and Metal Colour: Black Overall Dimensions: 21 x 15 x 15 mm (L x W x H)
Temperature Coefficient Type: NTC Thermal Time Constant: 10s Resistance 10kΩ Tolerance: ±1% Maximum Power Rating: 75mW Maximum Operating Temperature: +150°C Minimum Operating Temperature: -80°C Dimensions(dia.): 2 mm Length: 30mm Application: Compensation, Control, Measurement, etc.