High quality relay used 1-Channel Relay interface board Equipped with high-current relay : 12A @ 125V or 10AA @ 250V A Standard interface that can be controlled directly by microcontroller (Arduino , 8051, AVR, PIC, DSP, ARM)
Maximum operating speeds up to 2Mbps, GFSK modulation efficiency, Anti-interference ability, Particularly suitable for industrial control applications. Built-in hardware CRC error detection, Multipoint communication address control. Low-power 1.9 ~ 3.6V, only 1uA on Power down mode Built-in 2.4Ghz antenna Built-in voltage regulator Standard DIP Pitch Interface for embedded applications
LED colour: RGB Comm Pin -Anode pins Number of LED’s per board: 64 LED layout: 8 x 8 LED diameter: 5mm Forward voltage: 2V Forward current: 5 – 10mA Board Dimensions: 60 x 60 mm Number of pins: 16 (8 x 8) Pin length: 6mm
Features standard USB Type A Connector, can be directly plugged to Laptop 3.3V and 5V dual power output 3 LEDs: power indicator, data reception indicator, the data transmission indicator, working status Meets the USB2.0 specification requirements
The FT232RL USB to TTL Serial Adapter Module is a high-performance USB-to-UART interface board designed for programming microcontrollers, flashing firmware, and serial debugging. Built around the industry-standard FTDI FT232RL chip, it features selectable 3.3V and 5V logic levels, integrated RX/TX status LEDs, and a DTR pin for seamless automatic reset programming with Arduino Pro Mini, ESP8266, and STM32.
Voltage: 3-3.6V (recommended 3.3V) V. Maximum output power: +20dBm. Power-down mode current: 4.2uA. Operating Range: 1Km Antenna Gain (peak): 2Dbi. 2MB rate (Open area): 520m. 1MB rate (Open area): 750m. 250Kb rate (Open area): 1100m. It uses 2.4GHz global open ISM band, with license free. SPI interface facilitates the communication with MCU I/O port.
