Maximum operating speeds up to 2Mbps, GFSK modulation efficiency, Anti-interference ability, Particularly suitable for industrial control applications. Built-in hardware CRC error detection, Multipoint communication address control. Low-power 1.9 ~ 3.6V, only 1uA on Power down mode Built-in 2.4Ghz antenna Built-in voltage regulator Standard DIP Pitch Interface for embedded applications
Features standard USB Type A Connector, can be directly plugged to Laptop 3.3V and 5V dual power output 3 LEDs: power indicator, data reception indicator, the data transmission indicator, working status Meets the USB2.0 specification requirements
The FT232RL USB to TTL Serial Adapter Module is a high-performance USB-to-UART interface board designed for programming microcontrollers, flashing firmware, and serial debugging. Built around the industry-standard FTDI FT232RL chip, it features selectable 3.3V and 5V logic levels, integrated RX/TX status LEDs, and a DTR pin for seamless automatic reset programming with Arduino Pro Mini, ESP8266, and STM32.
Voltage: 3-3.6V (recommended 3.3V) V. Maximum output power: +20dBm. Power-down mode current: 4.2uA. Operating Range: 1Km Antenna Gain (peak): 2Dbi. 2MB rate (Open area): 520m. 1MB rate (Open area): 750m. 250Kb rate (Open area): 1100m. It uses 2.4GHz global open ISM band, with license free. SPI interface facilitates the communication with MCU I/O port.
Input voltage range: 4V-38V DC Output voltage range: 1.25V-36V DC adjustable. Output current: 0-5A. Output power: 75W. High efficiency up to 96% The built-in thermal shutdown function Built-in current limit function In-Built output short protection function
The 650nm 5V Red Laser Diode Module is a compact, high-performance laser emitter designed for robotics, optical alignment, counter sensors, and laser security systems. Featuring a copper-housed 650nm red diode, 5V DC operation, and a 3-pin breadboard-friendly header, it integrates seamlessly with Arduino, Raspberry Pi, and ESP32 microcontrollers.
It’s efficient up to 93% It can source a good amount of current The maximum output current: 2A Input voltage: 2V-24V DC The maximum output voltage: 5V-28V DC
Input Voltage: DC3.6V-6V Input Current: 2A-5A Output Voltage: DC 400KV (Please pay attention to safety when used) Input Line Length: about 100mm (red is positive) Output Line Length: about 160mm
Fully compliant USB 2.0 standard, backward compatible with USB1.1 Support System: Windows XP, Vista, Windows 7, Linux, MacOS, and WinCE5.0 drive Baud Rate Range: 75bps – 115200bps, up to 6Mbps Supports Plug, Play and hot-swap ( USB side) Better than using CH341D chip or similar chip to support the laptop USB port. Communication distance up to 1.2KM
The performance is much higher than LM2577. Non-isolated Boost converter. It has a non-synchronous rectifier. Low ultra wide input voltage 3 v ~ 32 v, the best is 5 ~ 32 v working voltage range; Low ultra wide output voltage 5 v ~ 35 v;
