“MAX485 TTL To RS485” has been added to your cart. View cart
-
-
Add to cart
- Relay Modules
1 Channel Relay Module, 30A with Optocoupler, Isolation 5V Supports, High and Low Triger, （with Guide Rail）
- ₹392
- Channel: 1 channel Comes with GUIDE RAIL Relay Voltage: 5V High impedance controller pin Pull-down circuit for the avoidance of malfunction One normally closed contact and one normally open contact Triode drive, increasing relay coil
-
-
-
-
-
-
Add to cart
- Relay Modules
1 Channel Relay Module, 30A with Optocoupler, Isolation 5V Supports, High and Low Triger
- ₹367
- Channel: 1 channel Relay Voltage: 5V High impedance controller pin Pull-down circuit for the avoidance of malfunction One normally closed contact and one normally open contact Triode drive, increasing relay coil
-
-
-
-
-
-
-
Add to cart
- Current and Frequency Meter, Digital Voltage
0.28inch 4.5-30V Two Wire DC Voltmeter Red
- ₹172
- Operating Voltage: 4.5-30 VDC It is a 2-wire display. LED Color: RED Current Consumption : < 15 mA. Accuracy: 0.1 V. Refresh Speed : Approx 200mS/time. Measure accurately up to? 3.6 V
-
-
-
-
-
Add to cart
- Current and Frequency Meter, Digital Voltage
0.28inch 0-100V Three Wire DC Voltmeter Green
- ₹97
- Measuring Range: 0-100 VDC It is a 3-wire display. LED Color: GREEN Current Consumption : < 10 mA. Accuracy: 0.1 V. Refresh Speed : Approx 200mS/time. Measure accurately up to? 3.6 V
-
-
-
-
-
-
Add to cart
- Relay Boards
ESP8266 ESP-01 5V WiFi Relay Module
- ₹216
- Onboard Module: ESP8266 wifi module; in AP mode it can connect with 5 Clients at the same time Operating Way: cellphone carried on wifi module; cellphone and wifi module carried on the same router, and use the APP to control relay Transmission Distance : 400m (max) Relay : 5V,10A/250V AC 10A/30V DC Baud Rate: 9600. Diode effusion protection; Short response time
-
-
-
-
-
Add to cart
- Modules
IIC/I2C/TWI/SPI Serial Interface Board Module For Arduino 1602 LCD Display
- ₹47
- 5V power supply. Serial I2C control of LCD display using PCF8574. Backlight can be enabled or disabled via a jumper on the board. Contrast control via a potentiometer. Can have 8 modules on a single I2C bus (change address via solder jumpers)address, allowing.
-
-
-
-
-
Add to cart
- Electronic Modules and Displays
MAX485 TTL To RS485
- ₹35
- On-board MAX485 chip, A low power consumption for the RS-485 communication, slew-rate limited transceiver. A low power consumption for the RS-485 communication Onboard then 5.08 (mm) pitch 2P terminal to facilitate RS-485 communication wiring. Slew-rate limited transceiver All pins of the chip have been lead to can be controlled through the microcontroller. Convenient RS-485 communication wiring Multiple Units can be…
-
-
-
-
-
-
-
-
Add to cart
- POWER REGULATOR
150W DC-DC Boost Converter 10-32V to 12-35V 6A Step-Up Adjustable Power Supply
- ₹170
- Input voltage :10-32V Output voltage: 12-35V (adjustable) Output Current: 10A (MAX) Input Current: 16A (MAX) (Please enhance heat dissipation if more than 10A) The non-isolated step-up power conversion module Onboard LED illuminates when the voltage is applied to the module Equips Multi-turn Potentiometer.
-
-
-
-
-
-
-
-
Add to cart
- Electronic Modules and Displays
PL2303 USB to Serial Adapter: Reliable USB to UART Converter for RS232 to USB Connections
- ₹85
- Adopt imported controller PL2303HX, which can stabilize the flash with high speed 500mA self-recovery fuse for protection Two data transmission indicator can monitor data transfer status in real time Reserve 3.3V and 5V pin interface, easy for the DDWRT of different voltage system that needs power The entire board is coated by the high quality transparent heat-shrinkable sleeve, making the…
-
-
-
-
Add to cart
- Electronic Modules and Displays
Solenoid Valve – 12V DC 3-Way Mini Electric for Air/Gas – FA 0520 F
- ₹200
- Operating Voltage: 12V DC Port Size: 5.5mm (All 3 i/o are of the same size) Power: Pneumatic Pressure: Vacuum Operating Temperature (°C): -10 to 60 Type: Air Valve
-
-
-
-
-
Add to cart
- Relay Boards
5V Dual Channel Relay Module with Optocoupler
- ₹100
- Low Level Trigger Relay Module Two separate LEDs for On/Off indication of the Relay. Triggering input voltage 3.3V – 5V Two separate LEDs for On/Off indication of the Relay Triggering input voltage 3.3V – 5V 4) Back EMF protection Back EMF protection 2 LEDs to indicate when relays are ON. Works with logic level signals from 3.3V or 5V devices…
-
-
-
-
-
-
Add to cart
- Electronic Modules and Displays
DS3231 Real Time Clock (RTC) Module
- ₹253
- 1 Hz output pin SQW. 32 KHz output pin 32K. Voltage Supply: 2.2 V ~ 5.5 V (for RTC). Time Format: HH: MM: SS (12/24 hr). Date Format: YY-MM-DD-dd. DS 3231 based RTC with 2032 Battery Holder.
-
-