“QC4.0 QC3.0 USB Type-C 6-35 V Step Down Buck Module” has been added to your cart. View cart
-
-
Add to cart
- Modules, POWER REGULATOR
Dual USB Output 9V / 12V / 24V / 36V Car Charger Switch 5V DC-DC Power Supply Module 3A Buck Regulator
- ₹249
- Input : 6V-40V Output : 5V / 3A (MAX) Efficiency : 92% (MAX) Switching frequency : 150KHZ High efficiency and low ripple. With USB power indicator light. Maximum output 3A (at the same time with two mobile phones).
-
-
-
-
-
-
Add to cart
- Modules, POWER REGULATOR
DC-DC 4.5-40V To 5V 2A USB Charger Step down Converter Voltmeter Module
- ₹249
- Input voltage: DC 4.5 ~ 40V. Output voltage: 5V (when the input voltage is between 6.5V ~ 40V). Output current: 2A. The voltmeter has an automatic calibration function. With reverse connection protection. With overheat protection and short circuit protection.
-
-
-
-
-
-
-
Add to cart
- Modules, POWER REGULATOR
QC4.0 QC3.0 USB Type-C 6-35 V Step Down Buck Module
- ₹579
- Input voltage range: 6V to 35V Output voltage: 5V Conversion efficiency: 90% to 97% Dimension:50x20x11 mm
-
-
-
-
-
-
Add to cart
- Electronic Components, Electronic Modules and Displays, Sensors
Momentary Tactile Push Button Module DC 5V Switch
- ₹49
- Operating Voltage: 5V Contact Resistance : 50mΩ max (initial) Electrically Life:100,000 cycles Environment temperature: -25°C to +105°C Operating Force: 180/230(±20gf) Seal temperature:250ºC-280ºC I/O pins: 3 pins
-
-
-
-
-
-
Add to cart
- Modules, Sensors
Two-Color LED Module (Red & Green)
- ₹59
- Operating Voltage:2.0v ~ 2.5v Current:10mA Diameter:3mm Wavelength:571nm + 644nm Beam Angle:150
-
-
-
-
-
Add to cart
- Modules, Sensors
M274 360 Degree Rotary Encoder Brick Sensor Module
- ₹75
- Model : KY-040. Type : Incremental Encoder. Cycles per revolution (CPR) : 20. Working voltage : 0 – 5V. Material : PCB + Brass. Mounting Nut Thread diameter: 6.6mm Weight : 10 gm.
-
-
-
-
Add to cart
- RFID Technology
PN532 NFC RFID Read / Write Module V3 Kit
- ₹549
- Module Size: 42.7mm x 40.4mm x 4mm Easy to change mode: with a small SMD toggle Switch, it becomes very easy to change among IIC, SPI and HSU modes Longer distance: the reading distance becomes 5~7cm, compared with 4~6 cm of last version Built in PCB Antenna, with 5cm~7cm communication distance On-board level shifter, Standard 5V TTL for I2C and…
-
-
-
-
-
-
-
-
Add to cart
- DISPLAY, Electronic Modules and Displays
1.3 Inch I2C IIC 4 pin OLED Display Module with VCC GND-Blue
- ₹490
- Display Colour: Blue Resolution : 128×48 pixels Driver IC: SH1106 Fully Compatible with Arduino Working temperature: -30°C ~ 70°C Factory configured for SPI protocol (can be easily changed to IIC)
-
-
-
-
-
-
Add to cart
- Electronic Modules and Displays, Solenoids and Electromagnets
1240 12V DC 0.6A 7.5W Solenoid for Electric Door Lock
- ₹450
- Holding force: 0.25kg Energized forms: intermittent Unlocking time: 1S Dimensions: 54 x 42 x 28 mm (LxWxH) High quality ultra-compact electric lock. Rustproof, durable, safe, convenient to use. Suction which tightly sucks the iron, thus locking the door. Applicable for being installed in the escape door or fire door electronic controlled system.
-
-
-
-
-
-
Add to cart
- Modules, POWER REGULATOR
MT3608 2A Max DC-DC Step Up Power Module Booster Power Module
- ₹75
- It’s efficient up to 93% It can source a good amount of current The maximum output current: 2A Input voltage: 2V-24V DC The maximum output voltage: 5V-28V DC
-
-
-
-
-
-
Add to cart
- Electronic Modules and Displays, Relay Boards
8 Channel Isolated 5V 10A Relay Module opto coupler For Arduino PIC AVR DSP ARM
- ₹349
- Channel: 8 channel Relay Operating Voltage: 5V One normally closed contact and one normally open contact Triode drive, increasing relay coil High impedance controller pin Pull-down circuit for the avoidance of malfunction Power supply indicator and Control indicator lamp Power supply and relay instructions, lit, the disconnect is off;
-
-
-
-
-
-
-
Add to cart
- Electronic Modules and Displays, Relay Boards
Single Channel 5V Relay Module without Optocoupler
- ₹42
- High quality relay used 1-Channel Relay interface board Equipped with high-current relay : 12A @ 125V or 10AA @ 250V A Standard interface that can be controlled directly by microcontroller (Arduino , 8051, AVR, PIC, DSP, ARM)
-
-