-
- Add to cart
- PIR, IR & Motion Sensors
Infrared IR Sensor Receiver Module for Arduino
- ₹69
- Operating Voltage:2.0v ~ 2.5v Current:10mA Diameter:3mm Wavelength:571nm + 644nm Beam Angle:150
-
- Add to cart
- Modules, Sensors
Two-Color LED Module (Red & Green)
- ₹59
- Operating Voltage:2.0v ~ 2.5v Current:10mA Diameter:3mm Wavelength:571nm + 644nm Beam Angle:150
-
- Add to cart
- Sensors
Photosensitive Resistor Sensor Module for Arduino
- ₹49
- This is a High-quality photosensitive sensor module/light module detects the photosensitive resistor for Arduino Resistance of the photoresistor is typically less than 80 Ohms (in full light) Dark resistance is typically greater than 20 Meg Ohms (in full darkness)
-
- Add to cart
- Sensors
Vibration Switch Module
- ₹72
- No direction, any angle can trigger the work. Sensitivity switches can be selected for the trigger sensitivity according to circuit requirements. This switch is suitable for the trigger of the small current circuit. Component Type: SW-18015P Maximum voltage: 12V Rated Heating Current: 20mA
-
- Add to cart
- Sensors
KY-017 Tilt Mercury Sensor Module
- ₹49
- The Mercury switch module and digital 13 interfaces come with LED to build a simple circuit, the production of tilt lights with the digital 13 interfaces comes with the LED, the mercury tilt switch sensor access to digital 3 interfaces, when the mercury tilt switch sensor has a button signal, LED light, and vice versa.
-
- Add to cart
- Sensors
Infrared Obstacle Avoidance Sensor Module
- ₹69
- Detection distance: 2-40cm IO Interface: 4-wire interfaces (- / + / S / EN) Output signal: TTL level Adjustment: adjust multi-turn resistance Effective angle: 35 °
-
- Add to cart
- Sensors
Tap Sensor Module for Arduino
- ₹59
- The knock sensor, detects the knocks and the taps. It can work like a switch. The sensor sends data momentarily to the board. To keep the LED on, the button state change codes should be used. So the sensor will work as a switch.
-
- Add to cart
- Modules, Sensors
M274 360 Degree Rotary Encoder Brick Sensor Module
- ₹75
- Model : KY-040. Type : Incremental Encoder. Cycles per revolution (CPR) : 20. Working voltage : 0 – 5V. Material : PCB + Brass. Mounting Nut Thread diameter: 6.6mm Weight : 10 gm.
-
- Add to cart
- Sensors
Analog Temperature Sensor Module HW-498
- ₹39
- Operating Voltage : 5v. Temperature measurement range : -55°C to 125°C. Measurement Accuracy : ±0.5°C.
-
- Add to cart
- Sensors
SMD RGB 3 Color LED Module
- ₹69
- RGB trichromatic limiting resistor to prevent burnout PWM adjusted color mixing Working voltage: 5V LED drive mode: Common cathode driver
-
- Add to cart
- Sensors
Mini Dry Reed Pipe Module
- ₹46
- Operating Voltage: 3.3V to 5v Output Type: Digital
-
- Add to cart
- Sensors
Dry Reed Pipe Magnetron Magnetic switch Module HW484
- ₹64
- Clean, good waveform driving ability, more than 15mA. Working voltage 3.3V-5 Output format: digital switching output (0 and 1) A fixed bolt holes for easy installation