Operating voltage: 2.3V to 5.5V 5.5V tolerant inputs Can operate at minus 40 degrees Celsius to 85 degrees Celsius Software reset feature (SWRST Call) allows the device via I2C bus reset 25MHz internal oscillator requires no external components The maximum allowable 50MHz external clock input
Supply Voltage: 12V Standard interfaces (as that of the extruder) Reserved GCI like I2C and RS232 3 MOSFET??s?are applied to the heater/ fan and thermistor circuit. Another 5A added to protect the component parts. An 11A fuse is added to the hotbed. Support 5 stepper drive board
Resolution: 8000 steps = 0.25us. UART: 9600 baud rate. Servo pulse range: 0.5ms to 2.5ms. Dimension :?48 x 46 x 14 (LxWxH) mm. 8 channels: Servo-driven independently. Extendable to 16 Channels: Two controllers linked together to drive 16 servos. Optional Position Reporting: User may request the position of an individual servo.
Compact size, easy to install and use. All jumpers hit the ON position to indicate 16 subdivisions (4988) or 32 subdivisions (8825). Jm connection motor: Jv Connects 5V and 12V-24V Power Supply. E /S /D /G of Jc corresponds to Enable /Step /Dir /Gnd driving signal output on the connection respectively.
8 sensor pairs spaced 16mm. 12V input power Onboard Mode and a Select button for instant configuration of LSA08 LCD display unit showing 8 sensors analog value with bar chart and line position. Simple Auto-Calibration function to the line following surface. Low current consumption (typically 26mA) Works on glossy or reflective surface Refresh rate up to 200Hz.
1. Up to 256 subdivisions; 2. Support SPI interface control; 3. Do not lose step when driving under high load; 4. Logic voltage: 3.3V/5V; 5. Input voltage range: 12V/24V DC; 6. Motor operating current 1.2a (peak 2A) can be adjusted 7. Spreadcycle ensures that the stepper motor has a smooth transition without dead zone current when passing zero.